6 checking the configuration, 7 maintaining lapb and x.25, 1 clearing the serial interface lapb statistics – Nortel Networks 8000 User Manual
Page 240: 6 checking the configuration -41, 7 maintaining lapb and x.25 -37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
7 LAPB and X.25 configuration
PVC
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface serial interface-number
The interface view appears.
Step 3
Run:
x25 xot pv^c pvc-number1 ip-ad^d^ress interface serial interface-number pvc pvc-number2
[ [ timer seconds ] [ retry times ] [ source serial interface-number ]
[ packet-size
input-packet output-packet ]
[ window-size input-window-size output-window-size ] ] *
The command configures PVC Keepalive and XOT-source attributes.
—End
7.6.6 Checking the configuration
Run the following commands to check the previous configuration.
Action
Command
Display X.25 XOT VC.
display x25 xot
7.7 Maintaining LAPB and X.25
This section covers the following topics:
Clearing the serial interface LAPB statistics
•
7.7.1 Clearing the serial interface LAPB statistics
To clear the LAPB statistics, run the following
reset
command in the interface view.
Action
Command
Clear the lapb statistics
of the serial interface
reset lapb statistics
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
7-37