7 configuring the ppp link quality detection, 7 configuring the ppp link quality detection -23, Configuring the ppp link quality detection – Nortel Networks 8000 User Manual
Page 150: Routing table
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
The interface view appears.
Step 3
Run:
ppp ipcp dns primary-dns-address [ secondary-dns-address ]
The command configures the DNS server address of the local negotiation.
By default, a router does not provide DNS server address for its peer.
—End
6.5.7 Configuring the PPP link quality detection
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The interface view appears.
Step 3
Run:
ppp Iqc close-percentage [ resume-percentage ]
The command enables the PPP link quality detection.
Using the
ppp Iqc
command, you can detect the quality of the low-speed line. The command
cannot be used on the high-speed POS interface.
—End
6.5.8 Configuring peer host router to be suppressed for adding
into the local end direct routing table
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The system view appears.
Step 3
Run:
ppp peer hostroute-suppress
6-24
Nortel Networks Inc.
Issue 5.3 (30 March 2009)