3 bundling an interface to the mfr interface, 3 bundling an interface to the mfr interface -19 – Nortel Networks 8000 User Manual
Page 309
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
8 Frame relay configuration
ip address ip-address { mask | mask-length }
The command configures the IP address of the MFR interface.
Step 4 Run:
fr interface-type dce
The command configures the FR interface type as DCE.
CQ NOTE
The fr interface-type dce command is valid only for MFR main interfaces.
Step 5 Run:
fr dlci dl ci-number
The command configures the DLCI of the interface.
Step 6 Run:
quit
Return to the interface view.
Step 7 Choose one of the following steps to configure the address mapping as required.
OQ NOTE
The fr inarp command is valid only for MFR main interfaces.
•
Run the
fr map ip {
ip-address
[
mask
] |
default }
dlci-number
[
broadcast [ ietf |
nonstandard ] ] command to add a static address mapping.
•
Run the
fr inarp [ ip ] [
dlci-number
] command to enable the dynamic address
mapping.
—End
8.4.3 Bundling an interface to the MFR interface
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface interface-type interface-number
The interface view appears.
Step 3 Run:
link-protocol fr mfr interface-number
The command binds the interface to the specified MFR interface
—End
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-19