Configuration procedure, Configuration files – Nortel Networks 8000 User Manual
Page 428
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10 Low-speed ATM configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
•
The VPI/VCI of the two PVCs connecting the router and DSLAM are 0/60 and 0/61,
pointing to ADSL Router A and ADSL Router B respectively.
Configuration procedure
Step 1
Create a VE interface and configure an IP address for it.
[RouterC] interface virtual-ethernet 0/0/1
[RouterC-Virtual-Ethernet0/0/1] ip address 202.38.160.1 255.255.255.0
[RouterC-Virtual-Ethernet0/0/1] quit
Step 2
Create a PVC and configure the IPoEoA mapping of PVC.
[RouterC] interface atm 1/0/0
[RouterC-Atm1/0/0] pvc to_adsl_a 0/60
[RouterC-atm-pvc-Atm1/0/0-0/60-to_adsl_a] map bridge virtual-ethernet 0/0/1
[RouterC-atm-pvc-Atm1/0/0-0/60-to_adsl_a] quit
[RouterC-Atm1/0/0] pvc to_adsl_b 0/61
[RouterC-atm-pvc-Atm1/0/0-0/61-to_adsl_b] map bridge virtual-ethernet 0/0/1
Step 3
Configure Router A and Router B.
The configurations on Router A and Router B are similar to Router C.
Step 4
Check the Configuration.
# Check the PVC status information on Router C.
[RouterC] display atm pvc-info
VPI/VCI |STATE|PVC-NAME
|INDEX
0/60
0/61
-|--
| UP
| UP
I to adsl a
I to adsl b
60
61
|ENCAP|PROT |INTERFACE
--- |----- |----- |--------
SNAP |ETH |Atm1/0/0 (UP)
SNAP |ETH |Atm1/0/0 (UP)
After the configurations are complete, you can ping PCs that are attached to Router A and
Router B c through the VE interfaces on Router C.
—End
Configuration files
Configuration file of Router C
#
sysname RouterC
#
interface Atm1/0/0
pvc to_adsl_a 0/60
map bridge Virtual-Ethernet0/0/1
pvc to_adsl_b 0/61
map bridge Virtual-Ethernet0/0/1
#
interface Virtual-Ethernet0/0/1
ip address 202.38.160.1 255.255.255.0
#
return
10-42
Nortel Networks Inc.
Issue 5.3 (30 March 2009)