Fault analysis, Troubleshooting procedure – Nortel Networks 8000 User Manual
Page 439
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
10 Low-speed ATM configuration
Fault analysis
After the PVC of Router A is faulty or deleted, the PVC that connects Router B does not sense
the status change of the remote PVC immediately, and the PVC of Router B still works
normally but lose the packets.
The OAM F5 Loopback function is a re-transmission detection mechanism, through which the
local PVC can sense the status change of the remote PVC immediately.
Configuring the OAM F5 Loopback function in the PVC of ATM can solve this problem.
Troubleshooting procedure
Do as follows on the routers:
Step 1
Enter the system view by running the
system-view
command.
Step 2
Enter the ATM interface view by running the
interface atm 1/0/0
command.
Step 3
Enter the PVC-Group view by running the
pvc-group 255/2047
command.
Step 4
Enter the PVC view by running the
pvc100/101
command.
Step 5
Configure the interface for sending the OAM F5 Loopback cell as one second by running the
oam frequency 1
command.
—End
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
10-53