3 configuring stm-1 cpos interfaces, 1 establishing the configuration task, Applicable environment – Nortel Networks 8000 User Manual
Page 76: Pre-configuration tasks, Data preparation, Configuration procedures, 2 configuring clock mode, 3 configuring ce1 interfaces -9, 1 establishing the configuration task -9, 2 configuring clock mode -15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
4 POS and CPOS interface configuration
4.3 Configuring STM-1 CPOS interfaces
4.3.1 Establishing the configuration task
Applicable environment
When the SONET/SDH optical interface bears packet data and low speed port access,
configure the CPOS interface.
03 NOTE
By default, the default configuration is adopted. The configuration procedure in this section is optional.
Pre-configuration tasks
None.
Data preparation
To configure a CPOS interface, you need the following data.
No.
Data
1
Number of the CPOS interface of the router
2
Overhead bytes C2, J0 and J1 of CPOS interface
Configuration procedures
No.
Procedure
1
2
3
4
Configuring AUG multiplexing route
5
4.3.2 Configuring clock mode
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-15