4 maintaining pppoe, 5 configuration examples, Networking requirements – Nortel Networks 8000 User Manual
Page 473: Configuration roadmap, 6 configuration example of ipoa -14, 4 maintaining pppoe -8, 3 configuring pppoe, Parameters
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12 PPPoE configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
12.4 Maintaining PPPoE
After confirming the statistics about the PPPoE session to be cleared, run the following
reset
command.
Action
Command
Clear the setup speed statistics of PPPoE
sessions.
reset pppoe-server session statistic interface
interface-type interface-number
12.5 Configuration examples
Networking requirements
The host uses PPPoE to access the Internet through the Router.
You connect the Router to the host through Ethernet interface 1/0/0, and to the Internet
through POS 2/0/0.
A
If you adopt the simple option, the password is stored in the configuration files in plain text.
You obtain the login user with low class the password by checking the configuration mode.
Therefore, you are recommended to use the cipher option.
Figure 12-1
PPPoE networking diagram
□
Host
GEI/0/^^^:^ POS2/0/0
Host
Router
POS2/0/0 / , ,
, ^
Configuration roadmap
The configuration roadmap is as follows:
1.
Configure the authentication mode as CHAP.
2.
Allocate the IP address pool.
3.
Configure the PPPoE protocol.
12-8
Nortel Networks Inc.
Issue 5.3 (30 March 2009)