4 example for configuring pppoeoa, Networking requirements, 4 example for configuring pppoeoa -38 – Nortel Networks 8000 User Manual
Page 431: Example for configuring pppoeoa
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
10 Low-speed ATM configuration
ppp authentication-mode pap
ip address 202.38.160.1 255.255.255.0
remote address pool 1
#
interface Virtual-Templatell
ppp authentication-mode pap
ip address 202.38.161.1 255.255.255.0
remote address pool 1
#
interface Atml/0/0
pvc to adsl a 0/60
map ppp Virtual-Template10
pvc to adsl b 0/61
map ppp Virtual-Template11
#
aaa
local-user user2 password simple pwd2
local-user user1 password simple pwd1
ip pool 1 202.38.162.1 202.38.162.100
#
return
10.12.4 Example for configuring PPPoEoA
Networking requirements
You dial the hosts in the two Ethernets the ATM network through an ADSL router, and
communicate with the router through DSLAM.
The WAN port of the router and the DSL interface of the ADSL router adopt the PPPoEoA.
Each host within the two Ethernets use a pre-installed PPPoE Client program to complete PAP
authentication with routers, and obtain the IP address from the remote AAA server of the other
side (not included in the following figure).
Figure 10-6
PPPoEoA configuration networking diagram
ADSL Router A
VT10: 202.38.160.1/24
VT11: 202.38.161.1/24
DSLAM
Router C
To ADSL Router A: 0/60
To ADSL Router B: 0/61
ATM1/0/0.1
ADSL Router B
PC
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
10-45