7 example for configuring frame relay over ip, Networking requirements, Data preparation – Nortel Networks 8000 User Manual
Page 356: Configuration procedure, 7 example for configuring frame relay over ip -66, Example for configuring frame relay over ip, Configuration roadmap
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
8.14.7 Example for configuring frame relay over IP
Networking requirements
As shown in Figure 8-10, you connect two FR networks through Router A and Router B.
Enable the FR over IP function on Router A and Router B to connect two FR networks over
an IP network.
Figure 8-10
Networking diagram of FR over IP
Configuration roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Configure the link protocol to FR.
Enable the FR switching in Router B and Router C globally.
Configure the working mode and the IP address of each interface and the VC number of
each network segment.
Configure the Tunnel interface.
Configure the FR over IP function.
Data preparation
To configure the FR over IP function, you need the following data:
•
The VC number of each network segment is shown in Figure 8-10
•
The IP address of Serial 2/0/0 on Router A is 10.120.20.1/24
•
The IP address of Serial 2/0/0 on Router B is 10.120.20.2/24
Configuration procedure
Step 1
Configure Router A.
• Enable the FR switching.
[RouterA] fr switching
8-66
Nortel Networks Inc.
Issue 5.3 (30 March 2009)