Pos and cpos interface configuration, About this chapter, 2 serial interface configuration -1 – Nortel Networks 8000 User Manual

Page 62

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Nortel Secure Router 8000 Series

Configuration -WAN Access

4 POS and CPOS interface configuration

POS and CPOS interface configuration

About this chapter

The following table shows the contents of this chapter.

Section

Description

4.1 Introduction

This section describes basic concepts of POS interfaces

and CPOS interfaces.

This section describes how to configure a POS interface.

See:Example for directly connecting routers through POS

interfaces

This section describes how to configure a CPOS
interface.

This section describes how to configure an E1/T1 channel
of CPOS interfaces.

See Example for configuring STM-1 CPOS interfaces.

4.5 Configuring synchronous

serial interfaces

This section describes how to configure synchronous

serial interfaces formed by the CPOS interface.

4.6 Maintaining POS and

CPOS interface

This section describes how to maintain the POS and

CPOS interface.

4.7 Configuration examples

This section provides several configuration examples for
POS and CPOS interfaces.

4.8 Troubleshooting

This section describes how to diagnose and remove the

fault on POS and CPOS interfaces.

Issue 5.3 (30 March 2009)

Nortel Networks Inc.

4-1