Configuring x.25 interface supplementary parameter – Nortel Networks 8000 User Manual
Page 221
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7 LAPB and X.25 configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
7.3.3 Configuring X.25 interface supplementary parameter
Do as follows on the routers.
Step 1
Run:
system-view
The system view appears.
Step 2
Run
interface serial interface-number
The interface view appears.
Step 3
Run:
x25 timer tx0 seconds
The timeout period of the procedure restart timer.
Step 4
Run:
x25 timer tx1 seconds
The timeout period of the call procedure timer.
Step 5
Run:
x25 timer tx2 seconds
The command configures the timeout period of the restore procedure timer.
Step 6
Run:
x25 timer tx3 seconds
The command configures the timeout period of the clearing procedure timer.
Step 7
Run:
x25 alias-policy match-type alias-string
The command specifies an alias for the interface.
Step 8
Run:
x25 ignore called-address
The command does not carry the called DTE address when a call is originated.
Step 9
Run:
x25 ignore calling-address
The command does not carry the calling DTE address when a call is originated.
Step 10
Run:
x25 response called-address
The command does not carry the called DTE address when a call response packet is sent.
Step 11
Run:
7-18
Nortel Networks Inc.
Issue 5.3 (30 March 2009)