Configuration procedures, 2 enabling or disabling x.25 switching, 3 configuring x.25 hunt group – Nortel Networks 8000 User Manual
Page 235: 2 enabling or disabling x.25 switching -32, 3 configuring x.25 hunt group -32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7 LAPB and X.25 configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
No.
Data
To configure X.25 switching route, you need:
• The forwarding address is a hunt group or an interface
• The X.121 address, source and destination address of the forwarding
Configuration procedures
No.
Procedure
1
Enabling or disabling X.25 switching
2
3
Configuring X.25 switching route
4
7.5.2 Enabling or disabling X.25 switching
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
x25 switching
The command enables X.25 switching.
—End
7.5.3 Configuring X.25 hunt group
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
x25 hunt-group hunt-group-name { round-robin | vc-number }
The command creates an X.25 hunt group.
Step 3
Run:
channel interface serial interface-number
7-32
Nortel Networks Inc.
Issue 5.3 (30 March 2009)
2