Nortel Networks 8000 - Manual (Page 157)

Nortel Secure Router 8000 Series
Configuration -WAN Access 6 PPP and MP configuration
ppp mp binding-mode { authentication | descriptor | both }
The command configures authentication binding mode.
Step 5 Run:
quit
Return to the system view.
Step 6 Run:
ppp mp user user-name bind virtual-template number
The command binds the VT with the MP user.
CD
NOTE
When a VT is bound to bind an interface, consider the following items:
• You must bind the physical interfaces into one VT in the same mode.
• All physical interfaces in one VT must be at the same interface board as the SR8000 does not
support trans-board MP binding.
• The number of the physical interfaces bound in one VT to interwork at two ends must be the same.
• Multiple physical interfaces are bound in one local VT. You must bind the peer interfaces directly
connected to those physical interfaces into one VT.
—End
6.7.3 Configuring a PPP interface to work in MP mode
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface interface-type interface-number
The interface view appears.
Step 3 Run:
ppp mp
The command configures the PPP interface to work in MP mode.
ED NOTE
The ppp mp command and the ppp mp virtual-template command are mutually exclusive. You must
configure an interface with only one of the two commands.
For configuration of PAP and CHAP modes, see Configuring unidirectional PAP or
Configuring unidirectional CHAP.
Issue 5.3 (30 March 2009) Nortel Networks Inc. 6-31