Configuration roadmap, Data preparation, Configuration procedure – Nortel Networks 8000 User Manual
Page 458
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
11 High-speed ATM configuration
Figure 11-2
Networking diagram for IPoA configuration
RouterB
To B: 0/42
Interface: ATM 1/0/0
Configuration roadmap
The configuration roadmap is as follows:
1.
Create the PVC of ATM interfaces on each router.
2.
Specify the protocol to bear the IP protocol.
Data preparation
To configure IPoA, you need the following data:
•
The IP addresses of their ATM interfaces of the three routers are 202.38.160.1/24,
202.38.160.2/24 and 202.38.160.3/24 respectively.
•
In ATM network, the VPI/VCI of Router A is 0/40 and 0/41, connecting with Router B
and Router C respectively.
•
The VPI/VCI of Router B is 0/40 and 0/42, connecting with Router A and C respectively.
•
The VPI/VCI of Router C is 0/41 and 0/42, connecting with Router A and B respectively.
Configuration procedure
Step 1
Configure Router A.
• Enter the ATM interface view, and configure an IP address for it.
[RouterA] interface atm 1/0/0
[RouterA-Atm1/0/0] ip address 202.38.160.1 255.255.255.0
• Establish PVC to bear IP.
[RouterA-Atm1/0/0] pvc to_b 0/40
[RouterA-atm-pvc-Atm1/0/0-0/40-to_b] map ip 202.38.160.2
[RouterA-atm-pvc-Atm1/0/0-0/40-to_b] quit
[RouterA-Atm1/0/0] pvc to_c 0/41
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
11-15