Data preparation, Configuration procedures, 2 configuring the switching pvc backup function – Nortel Networks 8000 User Manual
Page 317: Configuring the switching pvc backup function
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
8 Frame relay configuration
Configuring basic frame relay DTE capability or Configuring basic frame relay DCE
•
Create the tunnel interface and configure source and destination address for the
interfaces if the PVC is backed up through tunnel interfaces
Data preparation
To configure PVC standby groups of FR switching, you need the following data.
No
Data
1
FR interface number, IP addresses to be allocated and the VC number
2
Group number of PVC standby groups
3
Threshold of master PVC in the inactive state
4
Threshold of slave PVC in the active state
Configuration procedures
No.
Procedure
1
Configuring the switching PVC backup function
2
Configuring the automatic switching mode
3
Configuring the manual switching mode
4
8.7.2 Configuring the switching PVC backup function
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
fr switching
The command enables FR switching.
OQ NOTE
To enable the switching PVC backup function of FR, you must first run the fr switching command in
the system view to enable the FR switching function.
Step 3 Run:
fr switch name interface interface-type in-interface-number dlci in-dlci interface
interface-type out-interface-number dlci out-dlci group group-number
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-27