2 example for configuring ipoeoa, Networking requirements, Configuration roadmap – Nortel Networks 8000 User Manual
Page 427: Data preparation, 2 example for configuring ipoeoa -34, Example for configuring ipoeoa
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
10 Low-speed ATM configuration
interface Atm1/0/0
ip address 202.38.160.3 255.255.255.0
pvc to_a 0/41
map ip 202.38.160.1
pvc to_b 0/42
map ip 202.38.160.2
#
return
10.12.2 Example for configuring IPoEoA
Networking requirements
Connect multiple hosts in the two Ethernets to the ATM network through an ADSL router. The
hosts communicates with the router through the Digital Subscriber Line Access Multiplexer
(DSLAM).
The WAN port of the router and the DSL interfaces of the ADSL Router adopt IPoEoA.
Figure 10-4 Networking diagram of IPoEoA configuration
202.38.160.1/24
DSLAM
Router C
To ADSL Router A: 0/60
To ADSL Router B: 0/61
Virtual-ethemet1/0/0
PC
Configuration roadmap
The configuration roadmap is as follows:
1.
Create the virtual Ethernet interface.
2.
Create the PVC and specify the PVC to bear IPoEoA.
Data preparation
To complete the configuration, you need the following data:
• The IP address of the VE interface of the router is 202.38.160.1.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
10-41