Lapb and x.25 configuration, About this chapter, 7 lapb and x.25 configuration -1 – Nortel Networks 8000 User Manual
Page 204
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
7 LAPB and X.25 configuration
7
LAPB and X.25 configuration
About this chapter
The following table shows the contents of this chapter.
Section
Description
7.1 Introduction
This section describes basic knowledge about X.25 and
LAPB.
This section describes how to configure LAPB
parameters.
See Example for configuring LAPB.
7.3 Configuring an X.25
interface
This section describes how to configure an X.25
interface.
See:
• Example for directly connecting two routers by Using
• Example for connecting routers to an X.25 public
packet network
• Example for configuring the VC range
• Example for configuring X.25 sub-interfaces
7.4 Configuring X.25
datagram transmission
This section describes how to configure X.25 data
transmission and X.25 switching.
See:
• Example for configuring the TCP/IP header
compression
• Example for transmitting IP datagrams through X.25
PVC
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
7-1