Nortel Networks 8000 User Manual
Page 187
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
6 PPP and MP configuration
m
NOTE
To ensure the success of the MP binding, it is recommended to restart the binding sub-tunnel after the
configuration.
Step 4
Verify the configuration.
# Check the binding. In the following display, "Bundle Multilink" indicates the physical
interface is directly bound to the VT.
[RouterB] display ppp mp
Template is Virtual-Templatel
Bundle Multilink, 2 member, slot 1, Master link is Virtual-Template1:0
0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,
sequence 0/0 rcvd/sent
The bundled son channels are:
Seriall/0/0
Seriall/0/1
# Check the status of the VA.
[RouterB] display virtual-access slot 1
---------------- Slot 1-----------------
Virtual-Template1:0 current state : UP
Line protocol current state : UP
Description : NORTEL, Nortel Series, Virtual-Template1:0 Interface
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened,
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
5 minutes input rate 0 bytes/sec, 0 packets/sec
5 minutes output rate 0 bytes/sec, 0 packets/sec
3 packets input, 42 bytes, 0 drops
2 packets output, 28 bytes, 0 drops
On Router A, the similar information appears.
You can ping the IP address 8.1.1.1 of the peer end on Router B.
[RouterB] ping 8.1.1.1
PING 8.1.1.1: 56 data bytes, press CTRL_C to break
Reply
from 8 .1.1 .1: bytes=56
Sequence=1
ttl=255
time=29
ms
Reply
from 8 .1.1 .1: bytes=56
Sequence=2
ttl=255
time=31
ms
Reply
from 8 .1.1 .1: bytes=56
Sequence=3
ttl=255
time=29
ms
Reply
from 8 .1.1 .1: bytes=56
Sequence=4
ttl=255
time=31
ms
Reply
from 8 .1.1 .1: bytes=56
Sequence=5
ttl=255
time=30
ms
-- 8.1 .1.1 ping
statistics -- -
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 29/30/31 ms
ED NOTE
To bind MP, you bind the link to the specified virtual interface template. When you use the
ppp mp
virtual-template
number command, you must use the created virtual interface template correctly.
—End
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
6-61