2 enabling pppoe, 2 enabling pppoe -4 – Nortel Networks 8000 User Manual
Page 469
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12 PPPoE configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
No.
Procedure
2
Configuring the PPPoE service name at the server side
3
12.2.2 Enabling PPPoE
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view appears.
Step 3
Run:
pppoe-server bind virtual-template number
The command binds the interface with the VT.
—End
12.2.3 Configuring the PPPoE service name at the server side
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view appears.
Step 3
Run:
pppoe-server service-name service-name
The command configures the PPPoE service name.
—End
You must bind the interface to the virtual interface template (VT) before you configure the
name of the PPPoE server on the server interface.
Using the
undo pppoe-server bind
command, you can cancel the binding by invalidating the
pppoe-server service-name
command configured on the interface.
12-4
Nortel Networks Inc.
Issue 5.3 (30 March 2009)