4 checking the configuration, 3 configuring an x.25 interface, 1 establishing the configuration task – Nortel Networks 8000 User Manual
Page 215: Applicable environment, Preconfiguration tasks, Data preparation, 2 configuring pos interfaces -9, 9 checking the configuration -25, 1 establishing the configuration task -29, 2 lapb configuration
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7 LAPB and X.25 configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
7.2.4 Checking the configuration
Run the following commands to check the previous configuration.
Action
Command
Check information on the
interface.
display interface serial [
number
] [
| { begin | exclude |
include }
regular-expression
]
7.3 Configuring an X.25 interface
7.3.1 Establishing the configuration task
Applicable environment
To make the link performance better, you change some parameters of X.25 in addition to the
configuration.
Preconfiguration tasks
Before configuring an X.25 interface, complete the following tasks:
•
Powering on the router and start the router normally.
•
Connecting the interface and configuring the physical parameters of the interface.
Data preparation
To configure X.25 interface, you need the following data.
No.
Data
To configure the X.25 interface, you need:
• X.121address
• VC range
• Size of receiving window and that of sending window of VC
• Maximum size of packets received and sent
Additional parameters of x.25 datagram transmission include:
• Timer delay value of restart procedure
• Call procedure
• Restore procedure
• Clearing procedure
• The alias for an interface and the default upper layer protocol borne on X.25
7-12
Nortel Networks Inc.
Issue 5.3 (30 March 2009)
1
2