Configuration procedures, 2 creating e1/t1 channels, Creating e1/t1 channel of the clear channel mode – Nortel Networks 8000 User Manual
Page 80: 2 creating e1/t1 channels -19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
4 POS and CPOS interface configuration
No.
Data
1
Number of CPOS interface of the router
2
Number of the E1 or T1 channel
3
Number of the E1 or T1 channels whose timeslots are bound as channel-set,
timeslot number or timeslot range
Configuration procedures
No.
Procedure
1
2
Configuring frame format (optional)
3
Configuring clock mode (optional)
4
Disabling or enabling the E1/T1 channel
5
4.4.2 Creating E1/T1 channels
Où NOTE
One channel cannot work in both the clear channel mode and the channelized mode simultaneously. To
switch the working mode between these two modes, chancel the current channel and re-create a new
one.
Creating E1/T1 channel of the clear channel mode
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
controller epos cpos-number
The CPOS interface view appears.
Step 3
To configure the working mode of the channel, do as follows:
•
To create the E1 channel of the clear channel mode, run:
e1 el-number unframed
•
To create the T1 channel of the clear channel mode, run:
t1 tl-number unframed
—End
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-19