Nortel Networks 8000 - Manual (Page 343)

Nortel Secure Router 8000 Series
Configuration -WAN Access 8 Frame relay configuration
[RouterB-Serial2/0/0] fr dlci-switch 300 interface Serial1/0/0 dlci 100
[RouterB-Serial2/0/0] quit
Step 3 Configure Router C.
# Configure Serial 1/0/0 and NNI.
system-view
[RouterC] interface Serial1/0/0
[RouterC-Serial1/0/0] link-protocol fr
[RouterC-Serial1/0/0] fr interface-type nni
[RouterC-Serial1/0/0] fr dlci 300
[RouterC-fr-dlci-Serial1/0/0-300] quit
[RouterC-Serial1/0/0] quit
# Configure Serial 2/0/0.
[RouterC] interface Serial2/0/0
[RouterC-Serial2/0/0] link-protocol fr
[RouterC-Serial2/0/0] fr interface-type dce
[RouterC-Serial2/0/0] fr dlci 200
[RouterC-fr-dlci-Serial2/0/0-200] quit
[RouterC-Serial2/0/0] quit
# Configure the FR switching route on Serial 1/0/0.
[RouterC] fr switching
[RouterC] interface Serial1/0/0
[RouterC] fr dlci-switch 300 interface Serial2/0/0 dlci 200
[RouterC-Serial1/0/0] quit
# Configure the FR switching route on Serial 2/0/0.
[RouterC] interface Serial2/0/0
[RouterC-Serial2/0/0] fr dlci-switch 200 interface Serial1/0/0 dlci 300
[RouterC-Serial2/0/0] quit
Step 4 Configure Router D.
# Configure Serial 2/0/0.
system-view
[RouterD] interface Serial2/0/0
[RouterD-Serial2/0/0] link-protocol fr
[RouterD-Serial2/0/0] ip address 196.1.1.2 255.255.255.0
[RouterD-Serial2/0/0] quit
Step 5 Verify the configuration.
Run the display fr dlci-switch command on Router B to view the configuration information
and status information about the switching PVC, which are as follows:
[RouterB] display fr dlci-switch
Frame relay switch statistics for board 1
Status Interface(Dlci)
Active Serial1/0/0(100)
Active Serial2/0/0(300)
Interface(Dlci)
Serial2/0/0(300)
Serial1/0/0(100)
Run the display fr dlci-switch command on Router C to view the configuration information
and status information about the switching PVC.
Issue 5.3 (30 March 2009) Nortel Networks Inc. 8-53