Data preparation, Configuration procedures, 2 configuring frame relay switching route – Nortel Networks 8000 User Manual
Page 321: 2 configuring frame relay switching route -31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
8 Frame relay configuration
Data preparation
To configure FR over an IP network, you need the following data.
No
Data
1
FR interface number of a router, IP addresses to be allocated and the VC number
2
Interface number and IP addresses of the interface that carries IP services
3
Interface number, source address, destination address and VC number of the tunnel
interface required for FR switching route
4
PVC name used for FR switching
Configuration procedures
No.
Procedure
1
Configuring frame relay switching route
2
Configuring frame relay switching PVC
3
8.8.2 Configuring frame relay switching route
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
fr switching
The command enables FR switching .
Step 3
Run:
interface interface-type interface-number
The view of interface that carries IP services appears.
Step 4
Run:
fr dlci-switch in-d^lci interface tunnel interface-number dlci out-dlci
The command configures the route of FR switching.
You must configure the
fr dlci-switch
command on the tunnel interface of both GRE ends and
the DLCI numbers (out-dlci) must be the same.
—End
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-31