Nortel Networks 8000 - Manual (Page 23)

About this document
Nortel Secure Router 8000 Series
Configuration -WAN Access
Chapter Description
3 E-Carrier and
T-Carrier Interface
Configuration
This chapter describes E-Carrier and T-Carrier interface
related concepts including digital carrier system and
channelized, unchannelized and clear channel modes. It also
describes the configuration steps of various interfaces
including E1, CE1, CT1, CE3, along with typical examples.
4 POS and CPOS
Interface Configuration This chapter describes Synchronous Digital Hierarchy (SDH),
Synchronous Optical Network (SONET), Packet over
SONET/SDH (POS), and Channelized POS interface (cPOS
interface) related concepts. It also describes the configuration
steps of various interfaces including POS, STM-1 cPOS,
E1/T1 channels of the cOS interface, along with typical
examples.
5 Logical Interface
Configuration This chapter describes various logical or virtual interfaces
including sub-interface, virtual ethernet, virtual template,
mp-group, loopback and null interface. It also describes their
configuration steps, along with typical examples.
6 PPP and MP
Configuration This chapter describes Point-to-Point Protocol (PPP) and
MultiLink PPP (MP) related concepts including authentication
and link operation. It also describes configuration steps for
PAP authentication, CHAP authentication, MP direct binding
through the virtual template, MP authentication binding
through the virtual template, MP Binding using MP-group, MP
limiting parameters configuration, along with typical
examples.
7 LAPB and X.25
Configuration This chapter describes the rationale of the X.25 AND LAPB
table, the configuration procedure and the configuration
examples.
8 Frame Relay
Configuration
This chapter describes frame relay related concepts and
configuration steps for frame relay compression, LMI type,
frame relay switching, PVC standby groups, MFR, hello
packet parameters of the MFR bundle link, MFR bundle
identifier and MFR bundle link identifier, MFR restriction,
along with typical examples.
9 HDLC Configuration This chapter describes how to encapsulate an interface with
HDLC protocol and how to set the polling interval.
10 Low-speed ATM
Configuration
This chapter describes Asynchronous Transfer Mode (ATM)
broadband networking technologies and configuration steps
for low-speed ATM interface, IPoA application, IPoEoA
application, PPPoA application, PPPoEoA application,
PVC-group, and service type of a PVC, along with typical
examples.
11 High-speed ATM
Configuration
This chapter describes Asynchronous Transfer Mode (ATM)
broadband networking technologies and configuration steps
for ATM interface, IPoA application, and service type of a
PVC or a PVP, along with typical examples.
Nortel Networks Inc. Issue 5.3 (30 March 2009) 2