5 configuring synchronous serial interfaces, 1 establishing the configuration task, Applicable environment – Nortel Networks 8000 User Manual
Page 84: Pre-configuration tasks, Data preparation, Configuration procedures, 1 establishing the configuration task -20, 7 configuring synchronous serial interfaces -26, 4 configuring e1/t1, Channels of the c
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
4 POS and CPOS interface configuration
4.5 Configuring synchronous serial interfaces
4.5.1 Establishing the configuration task
Applicable environment
The synchronous serial interfaces formed by CPOS interface index through the slot/card/
interface/ channel number: channel-set. You can configure the following basic parameters for
the serial interfaces:
•
CRC check bits
•
MTU
•
Link protocol
•
Hold-interval of the link layer protocol
Pre-configuration tasks
Before configuring the synchronous interface, connect and configure the CPOS interface
properly.
Data preparation
To configure the serial interface, you need the following data.
No.
Data
1
Number of interface connected to the transfer device or the device on the other side
2
Attribute parameters of synchronous serial interface
3
Link protocol of synchronous serial interface
Configuration procedures
No.
Procedure
1
Configuring attribute parameters of synchronous serial interface (optional)
2
Configuring link layer protocol of synchronous serial interface (optional)
3
Configuring hold-interval of the link layer protocol for synchronous serial interface
(optional)
4
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-23