Data preparation, Configuration procedure – Nortel Networks 8000 User Manual
Page 342
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
1.
Configure the link protocol on each interface to FR.
2.
Configure the working mode of each interface.
3.
Configure the VC number of each network segment.
4.
Enable the FR switching on Router B and Router C in the system view.
5.
Configure the FR switching route.
Data preparation
To configure the FR switching route, you need the following data:
#
The VC number of each network segment is shown in Figure 8-7.
#
The IP address of Router A is 196.1.1.1/24.
#
The IP address of Router D is 196.1.1.2/24.
Configuration procedure
Step 1
Configure Router A.
# Configure Serial 1/0/0.
[RouterA] interface serial1/0/0
[RouterA-Serial1/0/0] link-protocol fr
[RouterA-Serial1/0/0] ip address 196.1.1.1 255.255.255.0
[RouterA-Serial1/0/0] quit
Step 2
Configure Router B.
# Configure Serial 1/0/0.
[RouterB] interface serial1/0/0
[RouterB-Serial1/0/0] link-protocol fr
[RouterB-Serial1/0/0] fr interface-type dce
[RouterB-Serial1/0/0] fr dlci 100
[RouterB-fr-dlci-Serial1/0/0-100] quit
[RouterB-Serial1/0/0] quit
# Configure Serial 2/0/0 and NNI.
[RouterB] interface serial2/0/0
[RouterB-Serial2/0/0] link-protocol fr
[RouterB-Serial2/0/0] fr interface-type nni
[RouterB-Serial2/0/0] fr dlci 300
[RouterB-fr-dlci-Serial2/0/0-300] quit
[RouterB-Serial2/0/0] quit
# Configure the FR switching route on Serial 1/0/0.
[RouterB] fr switching
[RouterB] interface Serial1/0/0
[RouterB-Serial1/0/0] fr dlci-switch 100 interface Serial2/0/0 dlci 300
[RouterB-Serial1/0/0] quit
# Configure the FR switching route on Serial 2/0/0.
[RouterB] interface Serial2/0/0
8-52
Nortel Networks Inc.
Issue 5.3 (30 March 2009)