Configuration procedures, 2 configuring the attributes of connection point – Nortel Networks 8000 User Manual
Page 417
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
10 Low-speed ATM configuration
No.
Data
5
Interval of sending OAM F5 Loopback cells
6
Number of the OAM F5 Loopback cells received correctly and continuously before
PVC becomes Up or Down
7
Interval of sending OAM F5 Loopback cells for retransmission detection before
PVC becomes Up or Down
Configuration Procedures
To configure ATM OAM loopback, perform the following procedures.
No.
Procedure
1
Configuring the Attributes of Connection Point
2
Configuring the Identifier for Specified Point of Loopback
3
4
5
Configuring the OAM F5 Loopback
6
10.10.2 Configuring the Attributes of Connection Point
Do as follows on the routers:
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
interface interface-type interface-number[.subinterface-number ]
The ATM interface view is displayed.
Step 3
Run:
oam
The OAM interface view is displayed.
Step 4
Run:
attribute vpi/start-vci [ vpi/end-vci ]
{ end-point | seg-point }
The OAM attributes of the connection point is configured.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
10-31