3 configuring mfr bundle link identifier, 3 configuring mfr bundle link identifier -40, Configuring mfr bundle link identifier – Nortel Networks 8000 User Manual
Page 330
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
Step 2
Run:
interface mfr interface-number
The command creates an MFR interface and the MFR main interface view appears.
Step 3
Run:
mfr bundle-name [ name ]
The command configures the bundle identifier.
By default, the MFR bundle identifier is "mfr + the bundle interface number".
CÛ NOTE
You use the
mfr bundle-name
command in the main interface of MFR but not in the sub-interface.
—End
8.11.3 Configuring MFR bundle link identifier
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The MFR main interface view appears.
Step 3
Run:
mfr link-name [ name ]
The command configures the name of bundle link identifier.
By default, the bundle link identifier is the name of current physical interface.
—End
8.11.4 Configuring hello packet parameters of MFR bundle link
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The interface view appears.
Step 3
Run:
8-40
Nortel Networks Inc.
Issue 5.3 (30 March 2009)