Step 4 – Nortel Networks 8000 User Manual

Page 183

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Nortel Secure Router 8000 Series

Configuration -WAN Access

6 PPP and MP configuration

[RouterB] interface serial2/0/0

[RouterB-Serial2/0/0] shutdown

[RouterB-Serial2/0/0] undo shutdown

[RouterB-Serial2/0/0] quit

[RouterB] interface serial2/0/1

[RouterB-Serial2/0/1] shutdown

[RouterB-Serial2/0/1] undo shutdown

[RouterB-Serial2/0/1] quit

ED NOTE

To ensure the success of MP binding, Nortel recommends you to restart all the bound sub-tunnels after

the configuration.

Step 4

Verify the configuration.

# Check the configuration on Router A.

[RouterA] display ppp mp interface Mp-group0/0/1

Mp-group is Mp-group0/0/1

===========Sublinks status begin======

Serial1/0/0 physical UP,protocol UP

Serial1/0/1 physical UP,protocol UP

===========Sublinks status end========

Bundle Multilink, 2 member, slot 0, Master link is Mp-group0/0/1

0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,

sequence 0/0 rcvd/sent

The bundled son channels are:

Serial1/0/0

Serial1/0/1

# Check the status of MP-group 0/0/2.

[Router] display ppp mp interface Mp-group0/0/2

Mp-group is Mp-group0/0/2

===========Sublinks status begin======

Serial2/0/0 physical UP,protocol UP

Serial2/0/1 physical UP,protocol UP

===========Sublinks status end========

Bundle Multilink, 2 member, slot 2, Master link is Mp-group0/0/2

0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,

sequence 0/0 rcvd/sent

The bundled son channels are:

Serial2/0/0

Serial2/0/1

You can ping through the IP address of the MP-group 0/0/2 on Router A.

RouterA]

ping

111.1 .1.2

PING 111.1.1 .2: 56

data bytes, press CTRL

C to break