Data preparation, Configuration procedures, Configuration file – Nortel Networks 8000 User Manual
Page 252
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
7 LAPB and X.25 configuration
Data preparation
To complete the configuration, you need the following data:
•
The PVC range is [1, 8].
•
Incoming-only channel range is [9, 16].
•
Two-way channel range is [17, 1024].
Configuration procedures
Step 1
Configure Router A.
[RouterA] interface serial 1/0/0
[RouterA-Serial1/0/0]
[RouterA-Serial1/0/0]
[RouterA-Serial1/0/0]
[RouterA-Serial1/0/0]
[RouterA-Serial1/0/0]
link-protocol x25
x25 vc-range in-channel 9 16 bi-channel 17 1024
ip address 202.38.160.1 24
shutdown
undo shutdown
Step 2
Configure Router B.
[RouterB] interface serial 1/0/0
[RouterB-Serial1/0/0]
[RouterB-Serial1/0/0]
[RouterB-Serial1/0/0]
[RouterB-Serial1/0/0]
[RouterB-Serial1/0/0]
link-protocol x25
x25 vc-range in-channel 9 16 bi-channel 17 1024
ip address 202.38.160.2 24
shutdown
undo shutdown
Step 3
Verify the configuration.
Pinging Router B on Router A succeeds.
—End
Configuration file
Configuration file of Router A
#
sysname RouterA
#
interface Serial1/0/0
link-protocol x25
x25 vc-range in-channel 9 16 bi-channel 17 1024
ip address 202.38.160.1 255.255.255.0
#
return
Configuration file of Router B
#
sysname RouterB
#
interface Serial1/0/0
link-protocol x25
x25 vc-range in-channel 9 16 bi-channel 17 1024
ip address 202.38.160.2 255.255.255.0
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
7-49