Configuration files, Networking requirements, Configuration roadmap – Nortel Networks 8000 User Manual
Page 188: This section de
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
Configuration files
•
Configuration file of Router A
#
sysname RouterA
#
interface Serial1/0/0
link-protocol ppp
ppp mp Virtual-Template 1
#
interface Serial1/0/1
link-protocol ppp
ppp mp Virtual-Template 1
#
interface Virtual-Template1
ip address 8.1.1.1 255.255.255.0
#
return
•
Configuration file of Router B
#
sysname RouterB
#
interface Serial1/0/0
link-protocol ppp
ppp mp Virtual-Template 1
#
interface Serial1/0/1
link-protocol ppp
ppp mp Virtual-Template 1
#
interface Virtual-Template1
ip address 8.1.1.2 255.255.255.0
#
6.12.6 Example for configuring MP authentication binding using
the VT
Networking requirements
You connect Router A and Router B through two pairs of serial ports. You perform MP direct
binding based on virtual-template as shown in Figure 6-4.
You are required to ensure that the serial 1/0/0 interfaces of Router A and Router B adopt PAP
authentication; while the Serial 1/0/1 interfaces of Router A and Router B adopt CHAP
authentication.
Configuration roadmap
The configuration roadmap is as follows:
1.
Configure the Serial 1/0/0 interfaces of Router A and Router B with PAP authentication.
2.
Configure the Serial 1/0/1 interfaces of Router A and Router B with CHAP
authentication.
6-62
Nortel Networks Inc.
Issue 5.3 (30 March 2009)