2 configuring the synchronous serial interface, 1 establishing the configuration task, Applicable environment – Nortel Networks 8000 User Manual
Page 47: Preconfiguration tasks, Data preparation, Configuration procedures, 2 configuring the synchronous serial interface -3, 1 establishing the configuration task -3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
2 Serial interface configuration
Its highest rate is 51.84 Mbit/s and it is the unchannelized interface.
Supports the working modes of the system self-loop and the line self-loop of the physical
chip.
Supports the automatic identification of the remote DTE and DCE equipment and the
automatic choice of the clock.
Supports the link layer protocol, PPP and HDLC.
Supports the IP network layer protocol.
2.2 Configuring the synchronous serial interface
2.2.1 Establishing the configuration task
Applicable Environment
You need to configure the synchronous serial interface when bears upper layer services.
Preconfiguration tasks
None.
Data preparation
To configure a synchronous serial interface, you need the following data.
No.
Data
1
Number of the synchronous serial interface of the router
2
Baud rate of the synchronous serial interface
3
MTU of the synchronous serial interface
Configuration procedures
No.
Procedure
1
Configuring link layer protocol type
2
3
4
Configuring DCD or DSR signal detection
5
6
Configuring idle mark between frames
7
8
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
2-3