Nortel Networks 8000 - Manual (Page 361)

Nortel Secure Router 8000 Series
Configuration -WAN Access 8 Frame relay configuration
fr map ip 10.110.40.2 100 ietf compression frf9
fr dlci 100
ip address 10.110.40.1 255.255.255.0
#
return
• Configuration file of Router B
#
sysname RouterB
#
interface Serial4/0/0
link-protocol fr
fr interface-type dce
fr map ip 10.110.40.1 100 ietf compression frf9
fr dlci 100
ip address 10.110.40.2 255.255.255.0
#
return
8.14.9 Example for configuring MFR
Networking requirements
As shown in Figure 8-12, you directly connect Router A and Router B through Serial
Serial4/0/0 and Serial4/0/1. Use the FR protocol bundle the two serial ports for broader
bandwidth.
Figure 8-12 Networking diagram of MFR bundle configuration
Router A
Serial4/0/0
'Serial4/0/1
MFR 4/0/100
10.1.1.1/24
Router B
Serial4/0/0
Serial4/0/1
MFR 4/0/200
10.1.1.2/24
Configuration roadmap
The configuration roadmap is as follows:
1. Create the MFR interface.
2. Bind the corresponding interfaces into the MFR interface.
3. Configure the working mode and the IP address of each interface.
4. Configure the VC number of the network segment.
Data preparation
To configure MFR, you need the following data:
• The IP address of the MFR interface on Router A is 10.1.1.1/24
• The IP address of the MFR interface on Router B is 10.1.1.2/24
• The VC number is 100
Issue 5.3 (30 March 2009) Nortel Networks Inc. 8-71