2 encapsulating the interface with ppp, 3 enabling ppp mru negotiation, 2 encapsulating the interface with ppp -8 – Nortel Networks 8000 User Manual
Page 134: 3 enabling ppp mru negotiation -8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/719075/134/background.png)
6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
No.
Procedure
2
3
6.2.2 Encapsulating the interface with PPP
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The interface view appears.
Step 3
Run:
link-protocol ppp
The command configures the link layer protocol as PPP.
By default, the protocol in the link layer is PPP for the serial and POS interface.
—End
6.2.3 Enabling PPP MRU negotiation
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface interface-type interface-number
The interface view appears.
Step 3
Run:
ppp mru-negotiate { ipv4 | ipv6 }
The command enables PPP MRU negotiation.
By default, the link control layer will perform IPv4 MRU negotiation.
If you configure IPv6 MTU for an interface, you need to enable PPP IPv6 MRU negotiation.
—End
6-8
Nortel Networks Inc.
Issue 5.3 (30 March 2009)