Nortel Networks 8000 User Manual

Page 197

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Nortel Secure Router 8000 Series

Configuration -WAN Access

6 PPP and MP configuration

Step 1

Check the current MP status by using the

display ppp mp

command. The interfaces that are

bound to the same MP should adopt the same binding method. Otherwise, the system regards
them as two different MP bindings.

Step 2

Check the binding modes of the interface on Router A. Set the sub-interfaces that connect

Router A with Router B and Router C respectively at the different interface boards, or change

the VT interface index in Router A.

Step 3

Check information about the interface by using the

display interface

command. Check

whether the configured parameters are validated. If not, use the

shutdown

command and the

undo shutdown

command in the bound VT physical interface view.

—End

Issue 5.3 (30 March 2009)

Nortel Networks Inc.

6-71