Data preparation, Configuration procedures, 2 enabling the mib collecting of the interface – Nortel Networks 8000 User Manual
Page 480: 3 enabling the router to send the trap packet, 2 enabling the mib collecting of the interface -3, 3 enabling the router to send the trap packet -3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
13 Medium-MIB configuration
Data preparation
None.
Configuration procedures
No.
Procedure
1
Enabling the MIB collecting of the interface
2
Enabling the router to send the trap packet
13.2.2 Enabling the MIB collecting of the interface
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Perform the following as required:
•
To enter the E1/CE1/CT1/CPOS interface view, run
controller { e1 | t1 | cpos } controller-number
•
To enter the POS interface view, run:
interface pos Interface-number
Step 3
Run:
interface mib-collect enable
The command enables the collection of the statistics information on the interface.
—End
13.2.3 Enabling the router to send the trap packet
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
controller { e1 | t1 } controller-number
The E1/CE1/CT1 interface view appears.
Step 3
Run:
interface medium-mib trap enable
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
13-3