5 maintaining atm, 6 configuration example of ipoa, Networking requirements – Nortel Networks 8000 User Manual
Page 457: 11 configuration examples -31, 5 maintaining atm -14, 4 configuring the service, Type of pvc, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
11 High-speed ATM configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
11.5 Maintaining ATM
A
CAUTION
Debugging affects the system performance. After the debugging, run the
undo debugging all
command to disable it immediately.
When ATM runs abnormally, run the
debugging
command in user view to debug the ATM
interface and locate the fault.
For the procedure of outputting the debugging information, refer to the chapter "Maintenance
and Debugging" in the Nortel Secure Router 8000 Series Configuration Guide - System
Management. For detailed debugging commands, refer to the Nortel Secure Router 8000
Series Command Reference.
Action
Command
Enable ATM error debugging.
debugging atm error
[
interface atm
interface-number [ .subinterface ] [
pvc
{ pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Enable ATM event debugging.
debugging atm event
[
interface atm
interface-number [ .subinterface ] [
pvc
{ pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Enable ATM packet debugging.
debugging atm packet
[
bridge
|
inarp
|
ip
]
[
interface atm
interface-number [ .subinterface ] [
pvc
{ pvc-name [ vpi/vci ] | vpi/vci } ] ]
Enable all ATM debugging.
debugging atm all
11.6 Configuration example of IPoA
Networking requirements
In Figure 11-2,connect routers A, B and C to the ATM network. All the PVCs on ATM
interfaces of the three routers use the IPoA application mode.
11-14
Nortel Networks Inc.
Issue 5.3 (30 March 2009)