Configuration procedures, 2 creating a vt and assigning an ip address, 3 directly binding the interface to an existing vt – Nortel Networks 8000 User Manual
Page 153: 2 creating a vt and assigning an ip address -27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
6 PPP and MP configuration
No.
Data
1
Interface number of the router
2
Number of the VT
3
IP address and subnet mask of the VT
Configuration procedures
No.
Procedure
1
Creating a VT and assigning an IP address
2
Directly binding the interface to an existing VT
3
Cû NOTE
You need to configure the local and the peer ends separately. The methods are the same.
6.6.2 Creating a VT and assigning an IP address
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface virtual-template number
A VT is created.
Step 3
Run:
ip address ip-address { mask | mask-length }
[ sub ]
The command assigns an IP address to the VT.
—End
6.6.3 Directly binding the interface to an existing VT
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
6-27