Allied Telesis AT-S70 - Manual (Page 80)

Chapter 5: Working with Line Cards
80
If you choose to change the operation mode of the line card TDM port.
The following prompt is displayed:
Change Operation Mode now? (Yes or No):
8. Type Y to accept the changes to the TDM port configuration, or type N
to cancel the changes.
9. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
10. From the System Configuration Menu, select Save Configuration
File.
Configuring the AT-CM70S UART Setting
To change the universal asynchronous receiver / transmitter (UART)
configuration on an AT-CM70S line card, perform the following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu is displayed, as shown in
Figure 12 on page 53.
2. Select an AT-CM70S line card.
3. Press .
The Module Configuration Menu is displayed, as shown in Figure 13
on page 55.
4. From the Module Configuration Menu, select TDM LIU (T1/E1)
Configuration.
The TDM Management Menu is displayed, as shown in Figure 24 on
page 76.
5. From the TDM Management Menu, select UART Configurations.
The UART Configuration Menu is displayed, as shown in Figure 28.
UART Configuration Menu
Module 15, Port C
> UART Local Console Mode
UART Back Plane Mode
Return to Port Configuration Menu ...