Allied Telesis AT-S70 - Manual (Page 228)

Chapter 9: SNMPv3
228
1-v1
Select this value if this User Name is associated with the SNMPv1
protocol.
2-v2c
Select this value if this User Name is associated with the SNMPv2c
protocol.
3-v3
Select this value if this User Name is associated with the SNMPv3
protocol.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying the Security Level
For the Security or User Name you have selected, the value of the
Security Level parameter in an SNMPv3 Target Parameter Table entry
must match the value of the Security Level parameter in the SNMPv3 User
Table entry.
To modify the Security Level parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80 on page 220.
4. From the Configure SNMPv3 Target Parameters Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is displayed, as
shown in Figure 81 on page 226.