Allied Telesis AT-S70 - Manual (Page 152)

Chapter 9: SNMPv3
152
Modifying an
SNMPv3 User
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. Refer to the following procedures:
ˆ “Modifying the Authentication Protocol and Password” on page 152
ˆ “Modifying the Privacy Protocol and Password” on page 155
ˆ “Modifying the Storage Type” on page 156
Modifying the Authentication Protocol and Password
To modify the Authentication Protocol and Password in an SNMPv3 User
Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
User Table.
The Configure SNMPv3 User Table menu is displayed, as shown in
Figure 62 on page 147.
4. From the Configure SNMPv3 User Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 User Table is displayed, as shown in Figure 63.
Figure 63. Modify SNMPv3 User Table Menu
5. To change the authentication protocol and password, select Set
Authentication Protocol & Password.
Configure SNMPv3 User Table
Modify SNMPv3 Table Entry
Set Authentication Protocol and Password
Set Privacy Protocol and Password
Set Storage Type
Return to Configure SNMPv3 User Table ...