Allied Telesis AT-S70 - Manual (Page 176)

Chapter 9: SNMPv3
176
The Modify SNMPv3 Table Entry menu is displayed, as shown in
Figure 69.
Figure 69. Modify SNMPv3 Table Entry Menu
5. To modify the Read View Name parameter, select Set Read View
Name.
The following prompt is displayed:
Enter Group Name:
6. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
7. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
The following prompt is displayed:
Enter Security Level [A-AuthNoPriv, P-AuthPriv, N-
NoauthNoPriv]:
Converteon
Configure SNMPv3 Access Table
Modify SNMPv3 Table Entry
Set Read View Name
Set Write View Name
Set Notify View Name
Set Storage Type
Return to SNMPv3 Access Table ...