Allied Telesis AT-S70 - Manual (Page 145)

AT-S70 Management Software User’s Guide
145
Configuring SNMPv3 Entities
This section describes how to configure SNMPv3 entities using the
SNMPv3 Tables. To successfully configure this protocol, you must perform
the procedures in the order given. For overview information about
SNMPv3, see the “SNMPv3 Overview” on page 136.
The following SNMPv3 tables are described:
ˆ “Configuring the SNMPv3 User Table,” next
ˆ “Configuring the SNMPv3 View Table” on page 159
ˆ “Configuring the SNMPv3 Access Table” on page 169
ˆ “Configuring the SNMPv3 Group Table” on page 186
ˆ “Configuring the SNMPv3 Notify Table” on page 195
ˆ “Configuring the SNMPv3 Target Address Table” on page 204
ˆ “Configuring the SNMPv3 Target Parameters Table” on page 219
The SNMPv3 User, View, Access, and Group tables are concerned with
setting up a user, determining authentication and privacy, and associating
a user to a security group. The SNMPv3 Notify, Target Address, and
Target Parameters tables are concerned with message notification. You
use the SNMPv3 Community Table to configure SNMPv1 and SNMPv2
communities.
Due to the complexity of the SNMPv3 configuration, Allied Telesis
recommends that you configure the SNMPv3 protocol with the procedures
listed above, in the order they are listed. However, you can configure the
SNMPv3 protocol using the above procedures in any order.