Allied Telesis AT-S70 - Manual (Page 170)

Chapter 9: SNMPv3
170
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68.
Figure 68. Configure SNMPv3 Access Table Menu
4. To create a group in the SNMPv3 Access Table, select Create
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Group Name:
5. Enter a descriptive name of the group. The Group Name can consist of
up to 32 alphanumeric characters.
The Group Name can consist of up to 32 alphanumeric characters.
You are not required to enter a unique value here because the
SNMPv3 Access Table entry is index with the Group Name, Security
Model, and Security Level parameter values. However, unique group
names allow you to more easily distinguish the groups.
There are four default values for this field:
ˆ defaultV1GroupReadOnly
ˆ defaultV1GroupReadWrite
ˆ defaultV2cGroupReadOnly
ˆ defaultV2cGroupReadWrite
These values are reserved for SNMPv1 and SNMPv2c
implementations.
Note
The Context Prefix and the Context Match fields are a read only
fields. The Context Prefix field is always set to null. The Context
Match field is always set to exact.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
Configure SNMPv3 Access Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...