Allied Telesis AT-S70 - Manual (Page 195)

AT-S70 Management Software User’s Guide
195
Configuring the SNMPv3 Notify Table
This section contains a description of the SNMPv3 Notify Table menu and
how to create, delete, and modify table entries. The Configure SNMPv3
Notify Table menu allows you to define a name for sending traps. For each
Notify Name, you define if a trap or inform message ia sent. The two
message types, trap and inform, have different packet formats.
For each Notify group, you can configure:
ˆ Notify Name
ˆ Notify Tag
ˆ Notify Type
ˆ Storage Type
The value of the Notify Tag is linked with the Tag List parameter in the
Configure SNMPv3 Target Address Table menu. As a result, the Notify
Tag parameter assigns a Target IP address to the Notify Table internally.
There are three functions you can perform with the Configure SNMPv3
Notify Table menu.
ˆ “Creating an SNMPv3 Notify Table Entry,” next
ˆ “Deleting an SNMPv3 Notify Table Entry” on page 197
ˆ “Modifying an SNMPv3 Notify Table Entry” on page 198
ˆ “Displaying the SNMPv3 Notify Table Menu” on page 202
Creating an
SNMPv3 Notify
Table Entry
To create an entry in the SNMPv3 Notify Table menu, perform the
following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Notify Table.