Allied Telesis AT-S70 - Manual (Page 210)

Chapter 9: SNMPv3
210
The following prompt is displayed:
Enter IP Address:
7. Enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying the Target Address UDP Port
To modify the Target Address UDP Port parameter in an SNMPv3 Target
Address Table entry, perform the following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77 on page 205.
4. From the Configure SNMPv3 Target Address Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is displayed, as
shown in Figure 78 on page 209.
5. To change the Target Address UDP Port, select Set Target Address
UDP Port.
The following prompt is displayed:
Enter Target Address Name:
6. Enter a previously configured Target Address Name.