Allied Telesis AT-S70 - Manual (Page 156)

Chapter 9: SNMPv3
156
messages transmitted between the host and the switch are encrypted
with the DES protocol.
N -None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
If you select None, proceed to step 10.
If you select DES, the following prompt is displayed:
Enter Privacy Password:
8. Enter a privacy password (with a minimum of 8 and a maximum of 32
alphanumeric characters) and press Return.
The following prompt is displayed:
Re-Enter Authentication Password:
9. Re-enter the password.
10. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
11. From the System Configuration Menu, select Save Configuration
File.
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 User Table entry, perform the
following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
User Table.
The Configure SNMPv3 User Table menu is displayed, as shown in
Figure 62 on page 147.