Allied Telesis AT-S70 - Manual (Page 208)

Chapter 9: SNMPv3
208
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 Group Table menu, type N to display the Next
Page and P to display the previous page.
4. To delete an SNMPv3 Target Address Table entry, select Delete
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a Target Address Name.
The following prompt is displayed:
Do you want to Delete this table entry? (Yes or No):
6. Enter Y to delete the selected table entry or N to save entry.
7. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
8. From the System Configuration Menu, select Save Configuration
File.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. Refer to the following procedures:
ˆ “Modifying a Target IP Address” on page 208
ˆ “Modifying the Target Address UDP Port” on page 210
ˆ “Modifying the Target Address Timeout” on page 211
ˆ “Modifying the Target Address Retries” on page 212
ˆ “Modifying the Target Address Tag List” on page 213
ˆ “Modifying the Target Parameters Field” on page 214
ˆ “Modifying the Storage Type” on page 216
Note
You cannot modify the Target Address Name parameter.
Modifying a Target IP Address
To modify the target IP address in an SNMPv3 Target Address Table
entry, perform the following procedure.