Displaying the snmpv3 target address table menu – Allied Telesis AT-S70 User Manual
Page 217

AT-S70 Management Software User’s Guide
217
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Target Address Table to the configuration file.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Target Address Table to the configuration file. Allied Telesis
recommends this storage type.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Displaying the
SNMPv3 Target
Address Table
Menu
This section describes how to display the Display SNMPv3 Target
Address Table menu. For information about the SNMPv3 Target Address
Table parameters, see “Creating an SNMPv3 Target Address Table Entry”
on page 204.
To display the Display SNMPv3 Target Address Table menu, perform the
following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77 on page 205.
4. From the Configure SNMPv3 User Table menu, select Display
SNMPv3 Table Entry.