Allied Telesis AT-S70 - Manual (Page 157)

AT-S70 Management Software User’s Guide
157
4. From the Configure SNMPv3 User Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 User Table is displayed, as shown in Figure 63
on page 152.
5. To change the storage type, select Set Storage Type.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter the User Name.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry:
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 User Table to nonvolatile memory.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 User Table to nonvolatile memory. Allied Telesis
recommends this storage type.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Displaying the
SNMPv3 User
Table Menu
This section describes how to display the Display SNMPv3 User Table
menu. For information about the SNMPv3 User Table, see “Creating an
SNMPv3 User Table Entry” on page 146.
To display the Display SNMPv3 User Table menu, perform the following
procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.